Suitable for Ageing test of PVC & Rubber
- BS 903 Part A19 method A for rubber
- BS 6746 (1976) method E for PVC.
- It confirms to IS 3400 (Part IV) 1978
Techinal Specification
- Dimensions of each Cell : 75mm dia x 305mm ht.
- Temp. Range : 5°C above ambient to 150°C
- Temp. Accuracy : ±1°C within the cell.
- Temp Variation : ±1°C cell to cell
- Supply : 240V AC Single Phase
Specification
Temperature Control
- By means of digital controller cum indicator to ±1°C
Safety Features
- Additional safety thermostat is provided to cut of dry heater supply in case temp. of overshoot.
- An energy regulator & 3 heat control is also provided to minimize the overshoot & undershooting of temp.
Electrically heated solid aluminum block oven
Diaphram pump at the bottom of the chamber develops unique preheated air flow system which ensures maximum uniform temp. & humidity condition inside each cell changes per hour through all the cells.Unique air flow assures quick recovery after door openings.
All the switches and controls are located conveniently on the bottom stand.
Air flow is regulated through a rotameter of suitable range.
The equipment is incorporated with Electrical timer 999 hrs with battery backup.
The unit is supplied with castor wheels for ease of movement.
Supplied complete with diaphragm pump, rotameter and air filter
Each cell is provided with double lid..
Additional Features :
3 heat control : Either by three heat switch or two tumbler switches
Energy Regulator : For fine adjustment of the temperature.
Safety Thermostat : To automatically take over the control in case digital controller fails to operate.
OPTIONAL FEATURES
Data Logger
CFR 21 part 11 compliance software for data logger
Data scanner complete with sensor
Safety digital temperature controller
Timer
