Humidity Oven
Technical Specification
- Temperature Range : 5 °C above ambient to 60°C
- Temperature Accuracy : ± 0.5°C
- Temperature Uniformity : ± 1°C
- Humidity Range : 5%Rh above ambient to 90%Rh
- Humidity Accuracy : + 2 % Rh
- Humidity Uniformity : + 3 % Rh
| Standard Model (S) | Inside S.S. 304 with mirror polish & outside mild steel powder coated. |
| GMP Model (G) | Inside S.S. 316 with mirror polish & outside stainless steel 304 with dull buff finish. |
Specification
- Double walled construction with backside triple.
- 3” Thick PUF Insulation ensures stable temperature with humidity & reduced energy consumption.
- Motorized Blower at back side of the chamber develops unique air flow system which ensures maximum uniform temperature & humidity condition inside the chamber.Unique air flow assures quick recovery after door openings.
- 1/12 HP, TEFC , F-class insulation, Single phase, 1440 RPM, 230 Volts
- High quality U shape S.S. Tubular Heaters are used for better heating.
- Steam injection system (Non condensing type) & reservoir tank with water level arrangement with indicator.
- Temperature Control
- Temperature Control : By means of Imported Microprocessor based auto tuned PID controller with CE mark & dual display of set value & process value.
- Humidity Control
- Humidity Control & Sensing : By means of Imported Microprocessor based auto tuned PID controller with CE mark & dual display of set value & process value with direct % RH.Direct RH electronic capacitor type humidity sensor, avoid wick cup & water.
- Safety Features
- Additional Safety thermostat to cut of dry heater supply in case temperature of overshoot.
- Float switch to cutoff the wet heater supply in case of low water level. Audio & Visual alarm.
- Compressor ON delay timer (2 min.) to safe guard the compressor.
- In built over load protector provided for hermetically sealed compressor.
- 50 mm validation port hole with silicon rubber seal to insert sensors for validation.
- Full view observation Acrylic door with gasket to observe sample inside the chamber.
- Interior illumination for Working area
- Specially designed stainless steel rod trays ensure uniform temperature distribution.
Models |
Capacity |
Internal size |
External Size H x W x D cm |
Trays |
TI – 701 S / G |
100 |
50 x 50 x 40 |
2 |
|
TI – 702 S / G |
170 |
70 x 60 x 40 |
77 x 106 x 162 |
2 |
TI – 703 S / G |
200 |
60 x 60 x 60 |
2 |
|
TI – 704 S / G |
285 |
80 x 60 x 60 |
3 |
|
TI – 705 S / G |
325 |
90 x 60 x 60 |
4 |
Note : Two blowers for 400 ltrs to 2000 ltrs. Capacity chambers.
OPTIONAL FEATURES
- Data Logger
- CFR 21 part 11 compliance software for data logger
- Data scanner complete with sensor
- SMS Mobile alert system
- Door access security system
- Safety digital temperature controller
- Timer
